Max LM-550A2 Series User Manual

42
FUNCTIONS
8. FUNCTIONS
The following table shows the setting items and their default values.
SETTING ITEM DEFAULT VALUE SETTING ITEM DEFAULT VALUE
Printed material MAX tube
Sequence No setting
Size of printed material No setting
Justification CENTER
Character size AUTO: ON
6, 9 mark (6 9)
Character width STANDARD
Printing density 4
Character space STD
Cutting position 0.0mm
Line space STD
Printing alignment 0mm
Pitch length
TAPE: 10.0 mm
LCD brightness 4
TUBE: 20.0 mm
ID PLATE: 10.0 mm
Auto power
-
off YES
Pitc
h cu
t
TAPE: LINE
ID PLATE: HALF-CUTTING
Position of printing line 0
TUBE: HALF-CUTTING
Printing style of
[RPT]&[SEQ]
A: 11,22,33
Vertical or horizontal HORIZONTAL
Frame NO
Feed the head of tube NO
Printing length
AUTO Low temp mode NO
Margin
2 mm each LCD backlight LIGHT
Repeat
TAPE: 1
TUBE: 2
Note: By pressing SHIFT BS (INIT.) in [INPUT screen], all of setting items can be
returned to the default values.
The italic characters show that these setting items are unable to return to the default
value by initializing.
8-1 SIZE
Setting the “CHARCTER SIZE” of the line at the cursor position.
The size can be set in each line. But, the different sizes cannot be set in the same line of the
same block.
1. Press SIZE . The [CHARACTER SIZE setting
screen] appears.
2. Press / key to select the value of the
“CHARACTER SIZE.”
3. Press
AUTO.”
Press / key to select “OFF.”
4. Press ENTER .
Selectable items: “SIZE” = 1.3, 2.0, 3.0, 4.0, 6.0 “AUTO” = ON, OFF
B
P
B
P

Max LM-550A2 Series Specifications

General

Brand	Max
Model	LM-550A2 Series
Category	Label Maker
Language	English