65
PRINTING
8-18 TUBE HEATER (only for the CE and A11 model)
In an environment with a temperature of 20°C or less, the tube may become hard,
and the printed letters may be blured or faint.
In this case, you can use a tube heater to warm and soften the tube to improve
the print quality. (Usable tube diameter φ2.5 to φ4.2)
The LED lamp for the HEATER part lights up, and machine heats up.
*When the temperature reaches a certain level, heat is automatically stopped and the LED
lamp turns off.
*If the tube is hard, please ajust heat by turning the temperature adjustment dial according
to the tube and temperature.
*If the tube is hard, please adjust heat by turning the temperature adjustment dial
according to the tube and temperature.
1. After entering the data, slide the tube heater down
until it clicks.
2. Insert the tube through the inlet.
3. Press the , select
[TUBE HEATER] with ▼, and press .
4. Select YES with the ◀ / ▶ keys and press
.
Warning
Never touch the tube entry/exit points.
There is a risk of burns.
ENTER
ENTER
5. Press .
Printing will start.
PRINT
IMAGE OPTIONS
Note: Tube heater compatible tube diameters are φ2.5 to 4.2 mm.
If a tube diameter other than the above, or for other materials, the tube heater cannot be
turned to ON.
After turning the tube heater to ON, if you select an unsupported tube corresponding size
or material, the tube warmer will be set to OFF.
When the power is turned off, the tube heater setting will be turned off.
Please note that if you continually leave the tube in with the tube heater on, the tube may
become too warm and printing may not perform normally.
The tube heater cannot be used when using a rechargeable battery.
At low temperatures ( 15 ° C or less), battery performance may deteriorate and normal
operation may not be possible, so be sure to use the AC adapter.
1
2
To Next Page
Loading...
Need help?
General
