25
LOADING THE CONSUMABLES
5-3 LOADING THE TAPE CASSETTE AND THE INK RIBBON CASE
1. Open the cassette cover.
2. Push the head release lever (blue) behind.
3. Slide the switching lever (silver) to the
right until it stops, as shown in the figure.
4. Load the tape cassette.
(1) Pass the tape through the guides. (2) Pull out the tip of the tape by about 4cm
(1-5/8”).
5. Make sure the ribbon is not slack.
If the ribbon is slack, rotate the winding
core toward the direction of the arrow
to remove the slack of the ribbon.
To Next Page
Loading...
