19
LOADING THE CONSUMABLES
When using with batteries, rechargeable nickel-metal hydride batteries can be used
[recommended: eneloop standard model AA (BK-3MCC) x 4: sold separately].
It is convenient because data being entered can be saved at worksites without power or even if
it's temporary power blackouts.
When using battery power, a mark will be displayed on the screen.
4
(only for the LM-550A2BH/PC CE, LM-550A2BH/PC and LM-550A2B/PC(IND) model)
-11
USE WITH A RECHARGEABLE BATTERY (Panasonic eneloop recommended).
Note: ･Please use eneloop standard model AA (BK-3MCC) x 4 rechargeable batteries.
(Recommendation)
Please note that if you use other batteries or rechargeable batteries, the printer
performance may not be fully realized, and it may not operate normally.
･When using other rechargeable batteries, please contact your local distributor.
Batteries are not included with this unit from the manufacturer.
Please use eneloop standard model AA (BK-3MCC) x 4 from Panasonic Corporation.
(Recommendation)
･This unit does not have a battery charging function. Please Be sure to use the dedicated
charger to charge the battery.
・ Be sure to turn off the power before setting or replacing the battery.
You can make about 500 marked tube blocks when fully charged.
The tube heater cannot be used when using batteries.
At low temperatures ( 15 ° C or less), battery performance may deteriorate and normal
operation may not be possible, so be sure to use the AC adapter.
* [eneloop] is a registered trademark of the Panasonic.
1. Remove the battery cover on the bottom
of the main unit.Lift the battery cover by
pulling the knob toward you.
2. Insert the battery paying attention to the
+ and - direction.
Please use a rechargeable nickel-metal
hydride battery [recommended: eneloop
standard model AA (BK-3MCC) x 4: sold
separately].
3. Align the packing of the battery cover
with the groove on the bottom of the main
unit, and fit it firmly.
Knob
Claw
To Next Page
Loading...
Need help?
General
