Max LM-550A2 Series - Underline; Sequence

49
FUNCTIONS
1. Move the cursor to the block which you want to set
underline, and press the key.
2. Pressing the ▼ / ◀ / ▶ keys, set underline to - YES
and press the key.
3.
When you move the cursor to the underlined block,
the underline mark is displayed on LCD.
8-9 SEQUENCE
S
8-8 UNDERLINE
You can set underline function for each block.
etting sequential (running) numbers. To activate “SEQUENCE” function, set the “START”
number and “END” number as below.
If the “SEQUENCE” is set,
appears.
1. Press SEQ . The [SEQUENCE setting
screen] appears.
2. After selecting the type of the “SEQUENCE” using
/ key, press ENTER .
The [START and the END number setting
screen] appears.
3. Press / key or Ten key to input the value of the
“START.”
Selectable items: 8 SCALE = 0 7777, 10 SCALE = 0
9999, 16 SCALE = 0 FFFF,
ALPHABET = A
Z, a z
B
P
B
P
B
P
Note: Underline can be set for each block, but it is not possible to set for specific characters in
the block. If [FRAME] is set , the underline can not be set.
RPT
ENTER
B
P
B
P
B
P
U