33
BASIC OPERATION
6-2 PRINTING ON THE TAPE
6-2-1 PITCH PRINT ON THE TAPE
Printing the following contents on the tape.
Tape size= 9mm Pitch length=15mm
U1
SLD SLD SLD SLD SLD SLD
COM COM
X18 X19 X1A X1B X1C X1D
15mm 15mm 15mm 15mm 15mm 15mm 15mm 15mm 15mm
1. Set “MATERIAL=TAPE” and “SIZE=9mm” in the [PRINTED MATERIAL setting screen].
2. [INPUT screen] appears. Make sure that the arrow symbol “
” is indicating “A” = capital letters.
Press / key to move the cursor to
.
3. Press PITCH to set “PITCH LENGTH.” (See
8-4-1: PITCH LENGTH) Press / key to set
“15.0.”
Press ENTER .
Note: It is also possible to input the value directly with
Ten key.
4. Press key to move the cursor after
.
Input U 1 . Press BLOCK to create a new
block.
5. Input S L D
, then X .
6. Press SEQ to set “SEQUENCE.”
(See 8-9: SEQUENCE)
Press / key to select “16 SCALE.”
To Next Page
Loading...
