13
QM00991-1
Introduction
Warnings, Cautions, and Notices (continued)
►Caring for the cabinet and remote control
• Incorrect care could cause not only an injury but adverse inuence such as
discoloration, peeling paint, etc. Take right care of the projector according to
the following.
• Wipe lightly with gauze or a soft cloth.
If the projector is extremely dirty, dip soft cloth in water or a neutral cleaner
diluted in water, and wipe lightly after wringing well. Then, wipe lightly with a
soft, dry cloth.
• Do not use an aerosol sprays, solvents, volatile substances or abrasive
cleaner.
• Do not allow long-term close contact with rubber or vinyl.
• Before using chemical wipes, be sure to read and observe the instructions.
►Keep the original packing materials for future reshipment.
• Be sure to use the original packing materials when moving the projector.
• Use special caution for the lens.
►Set the sound volume at a suitable level to avoid bothering other people.
• It is better to keep the volume level low and close the windows at night to
protect the neighborhood environment.
NOTICE
(continued on next page)
To Next Page
Loading...
