Maxell MP-JU4001 - Page 5

5
QM00991-1
Introduction
Warnings, Cautions, and Notices (continued)
►Do not get the product wet.
• It could result in a re, an electric shock, and/or malfunction to the projector.
• Do not place the projector near water, such as in a bathroom, kitchen, or
poolside.
• Do not place the projector outdoors or by the window.
► Do not place the projector on an unstable surface. Install the projector in
a stable position. Do not give the projector any shock or impact.
• If the projector should be dropped and/or broken, it could result in an injury,
and continued use could result in re or electrical shock.
• If the projector is shocked, immediately turn o󰀨 the power switch, disconnect
the power plug from the power outlet and contact your dealer.
• Remove all the attachments including the power cord and cables from the
projector when carrying the projector.
• Use the caster brakes placing the projector on a stand with casters.
• For special installation such as ceiling mounting, be sure to consult your dealer
beforehand.
• Install the projector in the way specied in "Setting up", "Arrangement", and
"Adjusting the projector's elevator".
• Do not put the projector on its side, front or rear position.
► Do not place the projector in the following place where oils or chemicals
are used:
- near the kitchen which oil smoke comes from
- oils such as machine oils or aromatic oils are used
- smoke or bubbles for a show or a performance are used
- solvents, medicines, or detergent volatiles or adheres
- corrosive gas is generated
Do not use adhesive such as threadlocker, lubricant and so on.
• Oils adhere to the product due to oil smoke, resulting in re, electrical shock, or
malfunction.
• Degradation of plastic harms the product, resulting in injury, re, electrical
shock, or malfunction due to falling from the ceiling, wall, or high mounted
position.
WARNING
(continued on next page)