Maxell MP-JU4001 - Page 6

6
QM00991-1
Introduction
Warnings, Cautions, and Notices (continued)
►Never disassemble and modify.
• The product contains high voltage components and/or laser light-emitting part
beyond the scope of Class 1 (IEC60825-1). Modication and/or disassembly of
the product could result in re, electrical shock, or injury to eyes or skin.
• Do not open or remove any portion of the product unless the manuals direct it.
• For internal maintenance, leave it to your dealer or their service personnel.
►Be cautious of high temperatures of the projector.
• High temperatures are generated when the light source is lit.
• Do not touch the USB wireless adapter while the projector is receiving AC
power.
• If combustibles or aerosol sprays are around the projector, it may cause re or
injury due to catching re or rupture.
• Do not install the projector near thermally conductive or ammable things.
• Do not touch around the exhaust vents during use or just after use, since it is
too hot.
►Never look through the lens or openings when the light source is on.
• A strong light is emitted when the projector’s power is on. Do not look into the
lens and the openings on the projector while the light source is on, since the
projection ray may cause a trouble on your eyes.
► When you turn o󰀨 the projected image while the light source is on,
follow the specied procedure.
• If you wish to have a blank screen while the light source is on, use the BLANK
function.
• Keep any object away from concentrated projection light beam. Blocking the
beam by something causes high temperature and could result in re or smoke.
WARNING
(continued on next page)