Maxell MP-JU4001 - Page 60

60
QM00991-1
INPUT menu
Item Description
COMPUTER IN
The computer input signal type for COMPUTER IN1 and IN2 ports
can be set.
(1) Use the ▲/▼ buttons to select the COMPUTER IN port to be
set.
(2) Use the ◄/► buttons to select
the computer input signal type.
(COMPUTER IN1)
AUTO
ó
SYNC ON G OFF
(COMPUTER IN2)
AUTO
ó
SYNC ON G OFF
ó
MONITOR OUT
• Selecting the AUTO mode allows you to input a sync on G signal
or component video signal from the port (

25).
• In the AUTO mode, the picture may be distorted with certain
input signals. In such a case, remove the signal connector so that
no signal is received and select the SYNC ON G OFF, and then
reconnect the signal.
FRAME LOCK
Sets the frame lock function on/o󰀨 for each port.
(1) Use the ▲/▼ buttons to select
the input ports.
(2) Use the ◄/► buttons to turn the
frame lock function on/o󰀨.
ON
ó
OFF
• This item can be performed only on a signal with a vertical
frequency of 49 to 51Hz, 59 to 61 Hz.
• When ON is selected, moving pictures are displayed more
smoothly.
MP-JW4001/MP-JW4011/MP-JW3501/MP-JW3511
• This function is unavailable for a signal from the HDMI 1 and
HDMI 2 (of 480i@60 or 576i@50 or 1080i@50/60) port.
(continued on next page)