Maxell MP-JU4001 - Page 89

89
QM00991-1
OPTION menu
Item Description
SERVICE
(continued)
CLONING
*
(continued)
The following items are exempted.
SETUP:
LIGHT SOURCE TIME, FILTER TIME
OPTION: SCHEDULE_DATE AND TIME,
SERVICE(GHOST)
NETWORK: PROJECTOR NAME
WIRELESS SETUP
(SIMPLE ACCESS POINT),
WIRELESS SETUP
(INFRASTRUCTURE)
AND WIRED SETUP
(IP ADDRESS, SUBNET MASK)
MY IMAGE, OTHER OPERATION
SECURITY: MY TEXT DISPLAY
• Operation is not available if SECURITY_
CLONING LOCK is ON.
• The Screen_MyScreen can only be loaded.
CLONING load function on STANDBY MODE
• While the projector is in STANDBY MODE, press
the
button of control panel together with the
► button, and then press the ▲ button to start
operating the CLONING load function.
• During loading process, POWER/STATUS1
indicator lights in orange and STATUS2 indicator
lights in red.
• After the loading process, POWER/STATUS1
indicator blinks 10 times and STATUS2 indicator
is o󰀨.
• If the loading fails (CLONING LOCK is ON),
POWER/STATUS1 indicator blinks 10 times and
STATUS2 indicator blinks 3 times.
• If the loading fails (CLONING LOCK is OFF),
POWER/STATUS1 indicator blinks 10 times and
STATUS2 indicator blinks 2 times.
• CLONING is invalid with the following conditions.
- CLONING LOCK is ON.
- If the STANDBY MODE is set to SAVING/
NETWORK(WOL).
- If there is no USB memory inserted into USB
TYPE A port.
- If PIN LOCK or lock of TRANSITION DETECTOR
is not being released.
- If a system error occurs.
- USB STANDBY PWR. is set to OFF.
* : MP-JW4001/MP-JW4011/MP-JW3501/MP-JW3511 only
(continued on next page)