Maxi Comet Executive Exec-56-G - Page 242

I-4
Index Comet Executive Gas
Tension Spring Replacement 7-37
Ribbon
Condition and Tension Check 4-12
Replacement
Feed 7-6
Return 7-38
Sets 5-6
Tension Adjustment
Feed 7-5
Return 7-37
Right Endframe Controls 3-4
S
Safety 1-3, 5-2
Flatwork Handling 3-9
Repair Safety Considerations 7-2
Safety Features 1-4
Safe Work Habits 1-3
Safety Considerations, Repair 7-2
Safety Device and Control Function Checkout 2-18
Control Function Check 2-19
Safety Device Check 2-18
Safety Features 1-4, 3-2
Main Disconnect Switch 1-4, 3-2
Safety Guards 1-5, 3-2
Safety Interlock Switches 1-5, 3-3
Safety Labels 1-5, 3-3
Safety Messages in this Manual 1-6
Safety Stop Buttons 1-4, 3-2
Safety Guards 1-5, 3-2
Safety Interlock Switches 1-5, 3-3
Safety Labels 1-5, 3-3
Safety Messages in this Manual 1-6
Safety Stop Buttons 1-4, 3-2
Safe Work Habits 1-3
During Daily Operation 1-3
Maintenance and Repair 1-3
Sail Switch
About 5-7
Sail Switch and Exhaust Blower Motor Electrical
Connection 2-8
Sail Switch and Exhaust Blower Wheel Check and
Clean 4-11
Scope of the Manual 1-2
Security of Hardware 2-16
Semi-Annual PM (1000 Hours) 4-15
Check
Gas Pressure 4-16
Mechanical and Electrical Connections 4-16
Sequence of Operation 5-11
Burner Operation Stage 5-12
JOG REVERSE Operation Stage 5-11
Mechanical Start-Up Stage 5-12
Stand-By Stage 5-11
Setscrews, Check 4-13
Shut-Down 3-11
Temporary Shut-Down 3-11
Site and Utility Requirements 2-2
Spring
Oil Tension 4-14
Replace Return Ribbon Tension 7-37
Standard Operating Procedures 3-6
Clearing a Jam Safely 3-10
Flatwork Handling 3-9
Shut-Down 3-11
Start-Up 3-6
Waxing 3-7
Stand-By Stage, Sequence of Operation 5-11
Start-Up 3-6
Step-Down Transformer 5-3
T
Task Tables, PM
Daily, Weekly Tasks 4-1
Monthly, Semi-Annual Tasks 4-2
Temperature Control
About 5-10
Replacement 7-34
Temperature Sensor Contact Shoes
About 5-10
Check and Clean 4-4
Replacement 7-33
Temporary Shut-Down 3-11
Tension Adjustment
Drive Chain 7-23
Feed Ribbon 7-5
Return Ribbon 7-37
Tension Spring, Oil 4-14
Timing Between Washing and Ironing, Conditioning
Flatwork Before Ironing 3-13
Tip Maintenance, Burner 7-32
Troubleshooting
Electrical 6-4
Exhaust System 6-16
Heating System 6-12
Ironing Quality 6-9
Mechanical System 6-6
Symptoms 6-2
U
Uncrating and Positioning 2-4
Unit Settings 3-14
TOC
INDEX