About
About this Document
ESCON Module 50/5 Hardware Reference
1-6 CCMC | 2021-08 | rel9051
1.1.4 Symbols & signs
In the course of the present document, the following symbols and signs will be used.
Table 1-2 Symbols & Signs
1.1.5 Trademarks and Brand Names
For easier legibility, registered brand names are listed below and will not be further tagged with their respec-
tive trademark. It must be understood that the brands (the list below is not necessarily concluding) are pro-
tected by copyright and/or other intellectual property rights even if their legal trademarks are omitted in the
later course of this document.
Table 1-3 Brand Names and Trademark Owners
Type Symbol Meaning
Safety Alert
(typical)
DANGER
Indicates an imminent hazardous situation.
If not avoided, it will result in death or serious injury.
WARNING
Indicates a potential hazardous situation.
If not avoided, it may result in death or
serious injury.
CAUTION
Indicates a probably hazardous situation or calls the
attention to unsafe practices. If not avoided, it may
result in injury.
Prohibited
Action
(typical)
Indicates a dangerous action. Hence, you must not!
Mandatory
Action
(typical)
Indicates a mandatory action. Hence, you must!
Information
Requirement /
Note / Remark
Indicates an activity you must perform prior
to continuing, or gives information on a particular item
you need to observe.
Best Practice
Indicates advice or a recommendation on the easiest
and best way to proceed.
Material
Damage
Indicates instructions on how to prevent damage to the
equipment.
Brand Name Trademark Owner
Littelfuse®
SMD NANO2®
© Littelfuse, USA-Chicago, IL
Windows® © Microsoft Corporation, USA-Redmond, WA
To Next Page
Loading...