11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713
50
NOTE: For an aluminum platform & fl ipover
equipped with retention ramp, 2” of
ground clearance is acceptable at
the tip of fl ipover.
STEP 11 - ADJUST PLATFORM (IF REQUIRED)
- Continued
5. Lower platform to the ground. Unfold platform
and fl ipover. RAISE the platform to bed height,
then LOWER it to the ground. The tip of fl ipover
and shackle should touch the ground as shown
in FIG. 50-1. Tip of fl ipover must not be higher
than 1/4” above the ground.
6. If the tip of fl ipover is more than 1/4” above
the ground (FIG. 50-2), note the distance “B”
above ground level. See the exception in the
NOTE above. Distance “B” will be used for
adjusting the platform later in this procedure.
FIG. 50-2
“B”
PLATFORM & SHACKLES
TOUCH GROUND
FIG. 50-1
TIP OF FLIPOVER
1/4”
(MAX.)
To Next Page
Loading...
