MAYBACH 62 - Page 117

115
Controls in detail
Locking and unlocking
Global locking
 Press the lock button at outside door
handle (
 page 76).
All turn signal lamps flash three
times. The locking knobs in the doors
move down. The anti-theft alarm sys-
tem is activated.
Global locking using the lock button at
trunk lid
1 Lock button at trunk lid
 Press lock button at trunk lid 1.
All turn signal lamps flash three
times. The locking knobs in the doors
move down. The anti-theft alarm sys-
tem is activated.
Restoring to factory setting
 Press and hold buttons Œ and ‹
simultaneously for about six seconds
until battery check lamp 6 flashes
twice.
i
You can also lock the vehicle using
the lock button at trunk lid
( page 115) or KEYLESS-GO locking/
closing switch (
 page 122).
i
To prevent a possible inadvertent
lockout, the trunk will open automat-
ically if a SmartKey with KEYLESS-GO
is recognized inside the vehicle or in
the trunk.
i
If the vehicle was previously centrally
locked with KEYLESS-GO, the trunk
will lock automatically after closing it.
The turn signals flash three times to
confirm locking.
i
You can also lock the vehicle using
the lock button at outside door han-
dle ( page 76) or KEYLESS-GO lock-
ing/closing switch (
 page 122).
!
If you can no longer lock or unlock
the vehicle with the SmartKey with
KEYLESS-GO, then either the batter-
ies in the SmartKey with KEYLESS-GO
are discharged, the SmartKey with
KEYLESS-GO is malfunctioning or the
vehicle batteries are drained.
 Check the batteries in the
SmartKey with KEYLESS-GO and
replace them if necessary
(
 page 429).
 Use the mechanical key to unlock
the driver’s door (
 page 423) and
trunk (
 page 424).
