How to Use the
DSC-TRACK
1. Switch the vehicle power ON.
2. Continue pressing the
DSC-TRACK
switch while the vehicle is stopped
until a sound is activated.
Press the
DSC-TRACK
switch again
to stop the DSC-TRACK operation.
For the TCS/DSC/KPC operation
condition, refer to How to Use the
Dynamic Stability Control (DSC) 5-66.
NOTE
If the engine is stopped with the
DSC-TRACK operational, the
DSC-TRACK
is canceled when the
engine is started the next time.
If the DSC-TRACK switch is pressed
and held for 10 seconds or longer,
the DSC-TRACK operation can no
longer be turned
off
even if the
DSC-TRACK switch or DSC OFF
switch is pressed. In this case, the
DSC-TRACK
switch or DSC OFF
switch will operate normally when
the vehicle power is switched ON
again after being switched OFF.
Driving
DSC-TRACK
5-69
MX-5_8ME4-EA-23L_Edition1_new 2023-8-31 16:47:34
To Next Page
Loading...
