Copyright © 2017 McCrometer, Inc. All printed material should not be changed or altered without permission of
McCrometer. Any published technical data and instructions are subject to change without notice. Contact your McCrometer
representative for current technical data and instructions.
www.mccrometer.com
3255 WEST STETSON AVENUE • HEMET, CALIFORNIA 92545 USA Printed In the U.S.A.
TEL: 951-652-6811 • 800-220-2279 • FAX: 951-652-3078 Lit. # 30120-48 Rev. 2.4 / 11-5-18
Contents
SAFETY ....................................................................................1
Safety Symbols .......................................................................1
Safety Warnings ......................................................................1
1.0 UNPACKING AND VERIFYING COMPONENTS ...........................................2
1.1 Unpack the Shipping Box and Verify Contents......................................2
1.2 Verify Serial Numbers ............................................................3
1.3 Verify Information On Cable Tags..................................................3
1.4 Tools Required for Installation ....................................................4
2.0 SENSOR PROBE INSTALLATION ........................................................4
STEP 1: Sensor Parts List with Part Numbers ............................................5
STEP 2: Detach The Cable Quick Connects...............................................7
STEP 3: Verify Sensor Installation Location - Upstream And Downstream Straight-Pipe Run
Recommendations ...............................................................7
STEP 4: Verify Sucient Installation Clearance From Obstructions ........................9
STEP 5: Pipe Valve Installation ........................................................10
STEP 6: Ensure correct sensor orientation ..............................................11
STEP 7: Optional Compression Seal Disassembly For Installation Of Large Sensors .......11
STEP 8: Sensor Installation Onto Pipe Valve ............................................12
STEP 9: Sensor Re-assembly After Optional Compression Seal Assembly Installation .....13
STEP 10: Insert The Sensor ............................................................14
STEP 11: Using The Sensor Insertion Tool - Optional ....................................15
STEP 12: Applying A Compression Load To The Sensor ..................................16
STEP 13: Installing The Short Retaining Rods...........................................17
STEP 14: Attaching the Ground Wire ...................................................18
3.0 SENSOR REMOVAL...................................................................19
4.0 ELECTRONICS INSTALLATION ........................................................20
5.0 MAINTENANCE ......................................................................20
6.0 SPECIFICATIONS.....................................................................21
7.0 RETURNING A UNIT FOR REPAIR ......................................................22
WARRANTY STATEMENT ...................................................................23
To Next Page
Loading...
Need help?
General
