McCrometer WATER SPECIALTIES FlowCom FC101 User Manual

30119-50 Rev. 2.2 | 23JUL2020
Page 26
PROGRAMMING
Gallons Per
Revolution
GPr
Show "GPr" onTotalizer line.
Blink current setting or display
blinking "00000" on Rate line.
Change Digit.
Digit blinks until selected.
Move Cursor Left to next
digit position.
Smoothing
Smooth
Default
"t 1"
Blink off, Save
Show "Smooth" on Totalizer line.
Blink current setting or display
blinking "no" on Rate line.
Change selection.
t 0
t 1
t 2
Display
P
9
8
7
6
5
4
3
2
1
0
Display
Default is
"00000". UP
arrow cycles
through each
digit. LEFT
arrow moves
to next digit
location, from
right to left.
From Register
Serial
Number Menu
GPr
Decimal
Place
GPr-dP
0
0.0
0.00
0.000
0.0000
Display
Default is "00000" (no
DP).
Cycles the DP from
current selection, from
right to left.
To
Trim 4 mA
Menu
Set Program
Lock Code
SEt-CodE
9
8
7
6
5
4
3
2
1
0
Display
Default is "0".
UP arrow cycles through
each digit. LEFT arrow
moves to next digit
location from right to left.
Limited to 4 digits
maximum.
It is very important to
record the code or the
program mode will be
locked out indefinitely..
Show "SEt-CodE" on Totalizer line.
Display existing code on Rate line.
P
Blink off, Save
P
P
Blink off, Save
P
P
Blink off, Save
P
P
Show "GPr-dP" on Totalizer line.
Blink current DP or display
blinking "00000" on Rate line.
Change Digit.
Digit blinks until selected.
Move Cursor Left to next
digit position.
Move DP. DP blinks
until selected.
Second Menu Level
3 Set-CodE
4 GPr-dP
5 GPr
6 Smooth

McCrometer WATER SPECIALTIES FlowCom FC101 Specifications

General

Brand	McCrometer
Model	WATER SPECIALTIES FlowCom FC101
Category	Measuring Instruments
Language	English