McCrometer WATER SPECIALTIES FlowCom FC101 User Manual

30119-50 Rev. 2.2 | 23JUL2020
Page 27
PROGRAMMING
Display
Display
Blink off, Save
P
P
Blink off, Save
P
P
Blink off, Save
P
P
Blink off, Save
P
P
From
Smoothing
Menu
Pulse Width
PLSwidth
Change value. Value
blinks until selected.
Show "PLSwidth" on Totalizer line.
Blink current setting or display ".02"
on Rate line.
Default is ".02".
Values in this
table are in
seconds.
5
1
.5
.1
.05
.02
To Reset
Total
Menu
20mA-AdJ
.03
.02
.01
.00
-.01
-.02
-.03
to -.50
Default is ".00".
Settings change
in .01 increments
Trim 20mA
PLS-tYPE
Show "PLS-tYPE" on Totalizer line.
Blink current setting or display "OPt"
on Rate line.
Pulse Type
Change value. Value
blinks un
til selected.
Change value. Value
blinks until selected.
PLS-tYPE
= OC ?
Yes
No
Trim 4 mA
4mA-AdJ
Change value. Value
blinks until selected.
Show "4mA-AdJ" on Totalizer line.
Blink current setting or display ".00"
on Rate line.
Show "4mA-AdJ" on Totalizer line.
Blink current setting or display ".00"
on Rate line.
Display
to .50
.03
.02
.01
.00
-.01
-.02
-.03
to -.50
Default is ".00".
Settings change
in .01 increments
Display
increase
decrease
increase
decrease
Note:
1. The pulse width setting is only available for a standard open collector output.
2. 4-20mA can be calibrated by adjusting the 4mA and 20mA trim values.
rEL
OC
OPt
Default is "OPt".
NOTES:
1. The pulse width setting is only available for a standard open collector output.
2. 4-20mA can be calibrated by adjusting the 4mA and 20mA trim values.
Second Menu Level
7 4mA-AdJ
8 20mA-AdJ
9 PLS-tYPE
10 PLSwidth **

McCrometer WATER SPECIALTIES FlowCom FC101 Specifications

General

Brand	McCrometer
Model	WATER SPECIALTIES FlowCom FC101
Category	Measuring Instruments
Language	English