SOLUTION
Remove spool from unit; disassemble.
Untangle line and wind correctly in
direction indicated on spool (see Section
8-1).
Trim off damaged line and rewind line
(see Section 8-1).
Remove spool. Check to be certain line
is wound in direction indicated on line
element (see Section 8-1).
Remove spool and install new line (see
Section 8-1).
Disassemble stringhead and examine
parts for damage. Replace parts or
entire head (see Section 8-1).
See Trimming Procedures (see section
7-3) or replace line (see section 8-1)
Use anti-seize compound and reinstall
knob HAND TIGHT ONLY.
Remove weed wrap (see Section 7-2).
PROBLEME
Line won’t feed.
Line snaps off or frays.
Unable to remove stringhead knob.
Stringhead and shaft are hot to the
touch.
CCAUSE PROBABLE
Line is tangled inside stringhead.
Upon removing spool, line appears to
be melted together.
Line wound in wrong direction inside
stringhead.
Insufficient line inside stringhead.
Internal damage to stringhead caused
by bumping too hard on ground while
advancing line.
Improper trimming procedures, or poor
quality line.
Stringhead knob overtightened.
Weed wrap.
10- TROUBLESHOOTING THE STRINGHEAD
19
PN 9096-334502 Printed in Taiwan
Modèle : MT3025/ MT30725
AVERTISSEMENT • LIRE ATTENTIVEMENT
Pour votre sécurité, lisez entièrement ce manuel avant d’utiliser votre nouvel outil. Le non respect des
instructions peut résulter en des accidents graves. Prenez quelques instants pour vous familiariser
avec le coupe-herbe avant chaque utilisation.
MANUEL DE UTILISATION
Coupe-herbes à essence
SECURITE
FONCTIONNEMENT
ENTRETIEN
MT3025
MT30725
To Next Page
Loading...
Need help?
General
