800-627-8569 23 Reel Disk from McFarlane Mfg.
2. If necessary, raise the unit and release the transport
locks from both wheel cylinders.
a. Remove the retainer clip and rotate the lock plate
upward.
b. Now pull up on the release lever and pull back to
release the transport locks from the cylinder.
c. Lock the release lever in the locked position, lower
the locking plate, and reinstall the retainer clip.
3. Adjust the disk gang angle by repositioning the
retainer pins and moving the disk gang into the
desired position using the following procedure. This
photo shows the disk gang set in the #2 position.
Note: On models with wings, make sure the disk gang
wing is unfolded before starting the adjustment
procedure.
a. Lower the disk gang close to the ground but not
touching.
Do not place any part of your body
under the disk gang.
To Next Page
Loading...
