McHale 991 High Speed Round Bale Wrapper
52
5. Thread the film through the dispenser
rollers, as per the threading diagrams
for the upper or lower dispenser.
6. Pull approximately 1.5 m of film away
from the dispenser and make a knot
at the end of the plastic film. Slide the
knotted end of the film in the slot
provided, as shown. Never attempt to
clamp plastic film in the cut & hold
mechanism.
7. Close the dispenser by releasing the
latch. The roll should now rest
against one of the aluminium rollers.
(Upper dispenser only)
8. Pull back the handle, with force and
push up on the dispenser latch and
then release the handle. (Lower
dispenser only)
Upper dispenser threading path
Lower dispenser threading path
To Next Page
Loading...
