McHale C430/C460/C470/C490 Bale Chopper
33
5. When the drawbar has been safely
connected to tractor and the machine
weight taken off, the drawbar stand
(2) can be rotated up, into the
transport position, by removing the
cross pin and linch pin. Align the
alternate hole and replace the cross
pin and linch pin. The drawbar stand is
to be used every time the machine is
disconnected from the tractor. Ensure
the lights are connected.
CAUTION
: Do not raise the lower link arms once the PTO is connected
Once the PTO shaft has been connected, the lower link arms cannot be
elevated beyond a certain point. Otherwise the link coupler will make
contact with the PTO shaft causing irreparable damage.
To Next Page
Loading...
