McHale C430/C460/C470/C490 Bale Chopper
55
8.2 Road transportation
Close the back loading door securely and ensure all panels are in position.
Ensure any bale or partial bale inside the chamber is secured and will not
move during transportation.
Clear the machine of loose forage, plastic, netting or mud.
Always ensure that the chute and slide extension are fully retracted.
Ensure safety chains on PTO cover sleeves are attached to both machine (as
shown) and tractor to prevent them from spinning.
Unlock the stand and swing it upwards into the transport position and secure
carefully using the lock-pin provided. (C460/C470/C490)
Ensure that the 7-pin light connector is attached to the tractor socket, and the
light fixtures are locked into the travel position. Confirm that all lights are
functioning correctly before travel.
The safety chain must be attached securely to the tractor.
Drawbar stand transport position (C460/C470/C490)
To Next Page
Loading...
