McHale C460 - Page 5

McHale C430/C460/C470/C490 Bale Chopper
5
6 Machine requirements & preparation 39
6.1 Chopper unit knife setting 39
6.2 Gearbox oil 40
6.3 Tyre inflation pressures (C460/C470/C490) 41
6.4 Drawbar & PTO stand usage (C460/C470/C490) 41
6.5 Machine adjustment 42
6.6 PTO shaft adjustment & maintenance 43
7 Electronic control system 46
7.1 Control box functions 47
7.2 Electronic control box setup 48
7.3 Control box features 49
7.4 Auxiliary control box 52
7.5 Warning messages 53
8 Road traffic safety & operation 54
8.1 Before travelling on any public roadway 54
8.2 Road transportation 55
9 Bale chopper operation & adjustments 56
9.1 Loading a bale 57
9.2 Distribution 60
9.3 Chute elevation 61
9.4 Chute rotation 62
9.5 Gear selection 63
9.6 Clearing a fan blockage 64
9.7 Knife section 65
9.8 Comb adjustments 66
9.9 Adjusting the rotor drive belt tension 67
9.10 Adjusting floor conveyor chain tension 68
9.11 Clamp silage side insert kits 69
10 Machine maintenance 70
10.1 Maintenance intervals 70
10.2 Tightening torque values 73
11 Storage 74
11.1 End of season 74
11.2 Start of season 75
12 Troubleshooting 76
12.1 Troubleshooting overview 76
13 Certification & Warranty 77
13.1 Declaration of Conformity 77
13.2 PDI form 77
13.3 Change of ownership pre-checks 77
13.4 Limited Warranty 77
14 Appendix 82
14.1 Adjusting the PTO shaft to the tractor 82
14.2 Unit conversion tables 83