PRE-DELIVERY INSPECTION (PDI)
Dealer:.............................................................. Model: C4 Series Bale shredder
Full address:...................................................... Serial No:..........................................................
.......................................................................... Date Delivered:.................................................
Fitter:................................................................. Date Inspected:.................................................
Customer:........................................................
Full Address:..................................................... Tel:....................................................................
.......................................................................... Mobile:..............................................................
.......................................................................... E-mail:...............................................................
ENSURE THAT THE TRACTOR IS OF THE CORRECT SPECIFICATION FOR THIS MACHINE.
REFER TO THE OPERATOR INSTRUCTOR MANUAL BEFORE MAKING ANY ADJUSTMENTS!
This machine must be registered on www.mchale.net by the Dealer
in order to qualify for Warranty!
1. Check that all accessories are with the
Owner/Operator. Check Operators
Instruction Manual and Parts Lists.
9. Ensure that continuous flow of the
tractor auxiliary valve is set to operate
with 30 l/min max.
2. Ensure machine is re-assembled
correctly. (Refer to all assembly
instructions supplied)
10. Check all manual functions on the
machine (using control unit on
electronic machines).
3.
Ensure that the wheels are correctly
fitted (i.e. valve to the outside). Torque
wheel nuts correctly.
(C460/C470/C490)
11. Run machine at low speed and check
for smooth operation of all moving
parts.
4. Check for correct tyre type, tread and
pressure. (Tyre inflation pressure is 3.1
bar (45 psi)) (C460/C470/C490)
12. Check that all electrics and lights
function correctly.
5. Ensure the drawbar or linkage is fitted
correctly before coupling the machine to
the tractor. Torque all bolts.
13. Use extreme caution when working
around sharp blades and tine-points.
6. When hitched to tractor check that the
machine is parallel with the ground.
Adjust drawbar or linkage, if necessary.
Attach 7-pin plug for lighting system.
14. The operator must be fully aware of all
hazards, controls (electric &
hydraulic), all functions & safety
devices of both the machine and the
tractor.
7. Connect hydraulic hosing to tractor and
ensure proper hydraulic setup. Note:
Ensure free-flow return to tank.
15. Ensure that the owner/operator reads
the operator instruction manual and
understands fully all safety &
operating aspects of the machine, as
described.
8. On electronic machines ensure control-
unit power is 12 V direct from battery or
a malfunction may occur.
16. Instruct operator on machine
maintenance i.e. check chain
tensions, adjustments, also areas to
be greased daily along with other
routine functions.
I am satisfied that the above checks have been carried out, and that the machine is complete with all
accessories and manuals.
Signed:................................................................................... (Dealer) Date:..............................
Signed:................................................................................... (Owner) Date:..............................
A signed copy of this form is to be retained by both the Dealer and the Customer!
To Next Page
Loading...
