EasyManua.ls Logo

MDC XT13 - Page 113

MDC XT13
125 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
112 | Page
www.mdcusa.co m
I
Ph: 833-632-8721
I
Page | 112
72 MONTHS / 36,000 mile SERVICE CHECKED
Chassis and Suspension
Hitch
Check hitch bolts to 90Nm/66ft lb.
Lubricate
Jockey Wheel
Inspect for condition and operation
Breakaway
Check for correct operation.
Inspect lanyard and clip
Drawbar
Inspect wiring grommets and general condition
Suspension
Torque bolts to 190Nm
Grease bushes and check for play.
Check torque on suspension hanger bolts (190nm)
Check retaining chain shackles tight.
Inspect shock absorber for condition.
Inspect shock absorber bushes
Brakes Inspect and adjust. Check lining thickness and drum wear
Wheel bearings
Replace bearings, seals and lubricate. Check stub axle condition and
wear. Replace split pin.
Wheel Nuts
Inspect condition and torque to (125Nm/92ft lb ½” studs)
(140Nm/103ft lb 14mm studs alloy rims) (200Nm/148ft lb 14mm
studs steel rims)
Tires
Inspect for abnormal wear, damage, and pressure.
Check manufacturing date less than 5 years.
Check sidewalls for perishing and damage
12 volt electrical
Lights
Check all trailer lights are functioning.
Check plug pins have gap.
Check for corrosion
Battery
Check terminals and voltage at full charge.
Check batteries are secure in cradles
Charging
Check battery charger settings are correct.
Check DC to DC charger settings are correct
Solar Panels
Check panels are free of damage.
Inspect sealants on cable penetrations and junction boxes
Cables
Inspect cables under body for damage to conduits.
Inspect cable glands and sealants on penetrations through floor
110 volt Electrical
RCD Unit
Check operation of RCD via test button
Shore power
input
Inspect shore power input plug and cover are free of damage
Earthing
Carry out resistance check
Caravan Body
Hatches & Doors
Check and lubricate locks
Seals
Check condition and correct latch/lock adjustment for correct 30-
50% compression
Body
Inspect joint sealants inside and out.
Ensuite joints checked for damage and adhesion.
Inspect for soft spots on floor
General fixings
Check all structural fixing are secure.
Ventilation
Inspect for obstruction and vents operating correctly

Table of Contents

Related product manuals