MDC XT13 - Operating Procedures

65 | Page
www.mdcusa.co m
I
Ph: 833-632-8721
I
Page | 65
Operating Procedures
Proceed as follows to fill the appliance with water:
1. Close open bypass lines (if present). Insert the water inlet filter or heating cartridge – if removed. 2, 7, 9 – 11.
2. Turn on fresh water supply or switch on water pump.
3. Fill the plumbing system.
• Open all water-release points, e.g., cold, and hot water faucets, showers, toilets.
It is important that you bleed the water system before starting the appliance.
Once water flows, the plumbing system is vented. Close the water-release points.
4. Start the appliance as follows:
Make sure that the LP gas supply is turned on.
Switch on the 12 V power supply (RV).
Open the access door (refer to “Opening the access door” on page 52).
Switch on the appliance at the POWER switch. Refer to “Switching ON the appliance” on page 56.
5. AquaGo comfort / AquaGo comfort plus:
Select the desired operating mode (refer to “Operating modes (control panel)” on page 56.
Close the access door (refer to “Opening the access door” on page 52).
Risk of damage in frost conditions.
In frost conditions, ambient temperatures below 39 °F (4 °C), there is
a risk that water in pipes, faucets and appliances could freeze. This
can cause considerable damage.
• Before you fill water into appliances and parts that transport
water, you must heat the installation area sufficiently so that the
water cannot freeze.
Scalding injuries caused by hot water!
Water temperatures over 127ºF (52ºC) can cause severe burns or
scalding and in extreme cases even death.
• Before using the hot water faucet or using the shower, allow
the hot water to run until the water temperature no longer increases.
• Test the temperature of the water before placing a child in
the bath or shower.
• Do not leave a child or an infirm person in the bath
unsupervised.