MDC XT13 - Draining the Water and Cleaning the Water Inlet Filter

71 | Page
www.mdcusa.co m
I
Ph: 833-632-8721
I
Page | 71
Maintenance
Repairs must be performed by a certified service technician. Truma recommends that the appliance be serviced
annually by a certified service technician. Verify proper operation after servicing.
Draining the water and cleaning the water inlet filter
To keep the appliance fully functional, clean the water inlet filter at least once a year.
1. AquaGo comfort / AquaGo comfort plus
Set the control panel to “Off”.
2. Remove the access door (refer to “Removing the access door” on page 53).
3. Switch OFF the appliance at the POWER switch.
4. Open all hot water faucets and wait for cold water. This will ensure that hot water is removed from the
appliance before draining.
5. Turn OFF the water supply or switch OFF the water pump.
High temperatures or repair attempts while the gas
supply is turned on may result in scalding injuries!
• Turn OFF the electrical power supply and the LP gas
supply before starting maintenance and repair
work.
• Allow the appliance to cool down.
• Never actuate the pressure relief valve as long as
the appliance is still hot.
Injuries caused by the Easy Drain Lever!
• Never actuate the Easy Drain Lever as long as the
appliance is under water pressure and/or is still
hot.
Sharp edges can cause cuts and injury!
• Always wear protective gloves to avoid injuries
from sharp edges during maintenance work.