EasyManua.ls Logo

MDC XT13 - Page 80

MDC XT13
125 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
79 | Page
www.mdcusa.co m
I
Ph: 833-632-8721
I
Page | 79
You have to switch the appliance off and on to unblock decalcification and enable further
operation.
g) Filling the water system
Tasks within the RV
Turn on fresh water supply or switch on water pump.
o Fill the water system. Open all water-release points, e.g., hot water faucets, showers,
toilets .
o Once water flows evenly, the water system is vented.
o Close the water-release points.
Before you use the water system and the appliance, check the color of the water at all faucets:
o Slightly red > rinse again.
o Clear > decalcification is finished.
Remove the warning signs “Caution decalcification in progress”
Interrupting decalcification
Decalcification is indicated through slow flashing (1 s on, 1 s off) of the status LED 3 (Fig. 9) on the control
panel.
Decalcification can be interrupted by switching the control panel to “Off”.
- Decalcification is interrupted after about 2 s.
- The status LED 3 (Fig. 9) on the control panel flashes quickly.
Irritation of skin and eyes in case of contact with decalcification agent. Wear protective gloves,
eye protection and face protection to avoid contact.
First you must take out the water inlet filter and remove any AquaGo decalcification tablets that it
may contain.
- To take out the water inlet filter, see “Draining the water and cleaning the water inlet filter” on page 15.
- Dispose of AquaGo decalcification tablets in accordance with local laws and regulations.
Before you use the water system again, you must rinse it (see step f) “Rinsing the water system” on
page 67) and fill it with water (see step g) “Filling the water system” on page 68).
Accessories
Electric antifreeze kit *
Truma offers an electric antifreeze kit (part no. 77400-01) that keeps the appliance frost-free to -4 °F (-20 °C)
while you are driving or if there is no gas supply. To operate the kit, you need a 12 VDC (120 W) power supply
from the vehicle’s on-board system. Ask your dealer.
* For AquaGo comfort / AquaGo comfort plus.
AquaGo decalcification tablets
Truma offers decalcification tablets (part no. 77300-01) to decalcify AquaGo comfort / AquaGo comfort plus.
Truma rear installation gas connection kit
Truma offers a rear installation gas connection kit (part no. 77000-37500) if installation from the back of the
appliance is required.
AquaGo comfort upgrade kit
Truma offers a kit (part. no. 77000-00005) to upgrade from AquaGo basic to AquaGo comfort.

Table of Contents

Related product manuals