EasyManua.ls Logo

MDC XT13 - Page 92

MDC XT13
125 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
91 | Page
www.mdcusa.co m
I
Ph: 833-632-8721
I
Page | 91
To exit ECO Mode, start battery charging. The BatteryPlus35-II will exit ECO Mode when the battery charges to
the Recovery voltage. Upon exiting ECO Mode, the BatteryPlus35-II will automatically return to its previous state
of operation.
When in ECO Mode you may temporarily turn on caravan loads for a short time by cycling the switch connected
the BatteryPlus35-II’s RSW input or the battery button on the Trek, Odyssey or Mobile Apps. This feature allows
you to retract slide-outs or electric steps.
STORAGE MODE
In Storage Mode, power to all loads and the accessories including battery monitors and remote controls will be
turned off.
To exit Storage Mode, start battery charging. The BatteryPlus35-II will exit Storage Mode when the battery
charges to the Recovery voltage.
When in Storage Mode you may temporarily turn on caravan loads for a short time by cycling the switch
connected the BatteryPlus35-II’s RSW input.
RECOVERY MODE
If a charging source is present and the battery voltage rises above 12.8V (lead acid) or 13.8V (LiFePO4), and the
shutdown was due to an LVD event, the BatteryPlus35-II will enter Recovery Mode and will resume normal
operation.
The BatteryPlus35-II-HA cannot recover and charge a heavily discharged LiFePO4 battery if it is only connected
to a solar input. It must be connected to a mains or AUX input to recover and charge a heavily discharged
LiFePO4 battery.
FOR MORE INFORMATION REFER TO THE BMPRO PRODUCT MANUAL.

Table of Contents

Related product manuals