26 Mecmesin MultiTest-dV Operating Manual
2. Testing
Icon Action
Pause test: This stops crosshead movement, leaving the stand in a state
of test readiness. The message is ‘Interrupted: User’ and the play button
is displayed as well as the stop button.
Emergency stop button pushed: Message: ‘Emergency Stop!!!’. Release
the emergency stop to regain control and remedy the situation before
resuming testing. Note there is no on-screen icon for the emergency
stop.
Upper limit switch triggered: The crosshead has reached the upper
travel limit, as set by the MultiTest-dV’s limit switches, and stopped.
Further travel in this direction is prevented.
Lower limit switch triggered: The crosshead has reached the lower travel
limit, as set by the MultiTest-dV’s limit switches, and stopped. Further
travel in this direction is prevented.
3. Stopped
Icon Action
Continue test sequence.
Stop test: This ends the test at this point
Move to the home position (start position from the beginning of the
previous test). This icon is only visible after pressing the stop
Exit to the test ready screen, leaving the crosshead in its current
position.
To Next Page
Loading...
