IMC15
20
13 System Monitor 136 Crash Info Displays shutdown and crash counter
- Shutdown counter: Number of untimely shutdown events.
If the last recorded rotation speed before power down is
above 75 Hz, the counter is incremented and the IMC15
locked by a ShutdownFlt.
- TDBWear: Shows state of wear of retainer bearings. The
counter is incremented under at least one of the following
conditions: ShutdownFlt, displacement fault at high speeds
(XFlt# at F
rotation
> nominal Speed / 2), axial integrator fault
(ItFlt4).
137 Orbit Displays orbits absolute and as percentage of the maximum
orbits
14 Properties 141 Version Info Displays version of
- Display: display code
- Program: program code
- Hardware: hardware (CPLD)
142 Inifile Info Displays selected inifile. Inifile selection is achieved by set-
ting jumpers on the connector X2 as follows:
- Inifile 1: X2:1->X2:8 open X2:1->X2:10 open
- Inifile 2: X2:1->X2:8 set X2:1->X2:10 open
- Inifile 3: X2:1->X2:8 open X2:1->X2:10 set
- Inifile 4: X2:1->X2:8 set X2:1->X2:10 set
143 Operating Hours Displays the operating hours
- Mains: operating hours on the mains
- Floating: operating hours with rotor levitating
- Rotating: operating hours with motor rotating (drive on)
144 Time and Date Displays the current time and date (GMT)
145 Calibration Gain Displays the calibration values of AMB (internal units)
146 Calibration Offset Displays the calibration offsets of AMB (internal units)
1 Main Menu
To Next Page
Loading...