IMC15
4
3 INTENDED USE
The IMC15 is intended for use in electrical plants or machines.
If used in machines, the commissioning of the IMC15 (start of
the intended use) has to be delayed until it has been verified
that the machine complies with the regulations of EU directive
98/37/EG (directive for machines). EN60204 has to be consi-
dered.
The technical data as well as the indications concerning instal-
lation have to be taken from the device label as well as from
this document. As a general rule, only motors and AMBs
approved by MECOS AG may be operated by an IMC15 having
the appropriate set of parameters.
The device has to be protected from any improper handling.
Please note that, during handling and transportation, no com-
ponents, hardware modules or parts of the housing are bent or
deformed such that insulating spacings may be altered.
Since electronic devices may fail, it is the user‘s responsability
(the customer‘s responsability in case of an OEM agreement)
that during a shutdown or a fault in the plant (machine) the
IMC15 is brought to a safe state.
The electrical installation has to be carried out according to
appropriate regulations, all information going beyond this
point have to be taken form this documentation.
Installation hint:
This equipment is intended for use in clean and dry environ-
ments in accordance to UL 61800-5-1, Pollution degree 2 and
Over Voltage Category III.
To Next Page
Loading...