Split Point
Pedal Assign
This function sets the pedal type to soft pedal,
sustain pedal, memory select pedal, start/stop
pedal. The default pedal is sustian pedal.
The LCD displays the type of pedal.
This function sets the point that separate the entire
keyboard to two section.
The LCD displays the split point value.
Use [+/YES] / [-/NO] or DIAL to change the split
point. You may also use keyboard to change the split
point by simply selecting the note you desired to be
the point of separation. The part below the split point
is the CHORD area.
Use [+/YES] / [-/NO] or DIAL to change the pedal assign.
Reverb Level
The LCD displays the reverb level. The level ranges
from 0 to 127. The default value is floating and
follows the voice.
Use [+/YES] / [-/NO] or DIAL to change the reverb
level.
1
1
1
2
2
2
FUNCTION
NEXTBACK
+/YES-/NO
FUNCTION
NEXTBACK
+/YES-/NO
Portamento Time
The LCD displays the type of portamento.
Use [+/YES] / [-/NO] or DIAL to change the type of
portamento.
There are 3 types from 1-3. The default value is 2.
1
2
3
FUNCTION
NEXTBACK
+/YES-/NO
FUNCTION
NEXTBACK
+/YES-/NO
Portamen
24
DZBPFB0DQXDOB*BSGIDZBPFB0DQXDOB*BSGI
To Next Page
Loading...
Need help?
General
