12 man_digiflex_com_en_02_5.doc
The user is under an obligation to report any changes in the Digiflex Com
to the supervisor responsible without delay.
The operator is under an obligation to shut the Digiflex Com down
immediately in the event of a malfunction which detracts from the safety of
staff. The Digiflex Com must only be put back into operation once the
malfunction has been rectified.
ELECTROTECHNICAL INSTRUCTIONS
Connect the Digiflex Com and all its accessories according to instructions
and regulations. Make sure the relevant regulations such as EN, DIN, VDE
or national standards, respectively, are observed.
Repair and maintenance work must only be carried out when the unit is
switched off (dead) and then only by a skilled electrician in accordance with
current accident prevention regulations. A skilled electrician in the sense of
the accident prevention regulations is a person who can assess the work
assigned to him/her and recognise possible dangers on the basis of his/her
technical training, knowledge and experience, and of his/her knowledge of
the relevant regulations.
1.4 Indications used in the description
Important instructions concerning personal protection, work safety and
technical safety are indicated as follows:
CAUTION
Caution indicates work and operating procedures which
must be complied with in full to prevent the Digiflex Com
and/or its peripherals from being damaged or ruined.
NB
NB indicates special technical requirements to which the
user must pay particular attention when using the Digiflex
Com.
Equipment protected by double insulation or reinforced
insulation.
To Next Page
Loading...
Need help?
General
