man_digiflex_com_en_02_5.doc 45
4. NIMH ACCUMULATOR CHARGER
4.1 Charging the Accumulator
First connect the cable from the plug-in mains unit to the DC-IN socket of
the charger, and only then plug the mains unit into a mains outlet.
Now insert the appropriate NiMH rechargeable accumulator into the
charger case until it engages gently.
The indicator lamp shall light up red after the accumulator has been
inserted.
After charging has been completed (approx. 4 hours), the indicator lamp
will light up green. You may now remove the accumulator or leave it in the
charger.
4.2 General Instructions on How to Handle a NiMH
Accumulator
ATTENTION
Do not short-circuit a accumulator.
Do not dismanntle or modify a accumulator.
Do not dispose of in fire.
Protect batteries from moisture.
Do not expose batteries to strong impacts.
Make sure that a damaged accumulator is disposed of
immediately and properly.
NOTE
A NiMH accumulator may heat up when being charged or
discharged. This is normal and does not indicate a defect.
Dispose of batteries which cannot be used any longer
properly or submit it for RECYCLING.
To Next Page
Loading...
Need help?
General
