46 man_digiflex_com_en_02_5.doc
4.2.1 Safety Precautions
Protect the device from moisture.
Do not cover the ventilation slots of the plug-in mains unit.
Do not insert any items into the ventilation slots.
Never expose to direct heat or direct sunlight.
Do not open the device as there are no user-maintained components
inside and any warranty might be invalidated.
Do not store or use charger and mains unit in the close vicinity of storage
media.
Only use the plug-in mains unit supplied.
4.2.3 Practical Hints
In order not to reduce the service life of a NiMH accumulator unnecessarily,
make sure that the accumulator is at room temperature when charging is
started.
"Overnight charging" will not cause any trouble since an intact accumulator
cannot be overcharged. Once charging has been completed, the device will
change over to trickle charging to compensate for natural self-discharge.
The optimum way of operation is to have two accumulators, with one
remaining in the charger while the other one is used for powering the
Digiflex Com.
The charger and the inserted accumulator will heat up during charging
(hand hot). This is normal and does not indicate any defect.
When the operating life of a accumulator becomes perceptibly shorter even
at full charge, you will need to replace it with a new one.
To Next Page
Loading...
Need help?
General
