Install the product on incombustible materials such as metal. Failure to comply will result in a fire.
Do not install the product near combustible objects. Failure to comply will result in a fire.
Do not install the product in places with explosive gases. Otherwise, there will be an explosion.
The wiring work must be done by professional personnel. Otherwise, there will be an electric shock.
Before wiring, check that the main and control power supplies are cut off. Otherwise, there will be an electric
shock.
Properly connect the grounding terminal of the drive. Otherwise, there will be an electric shock.
Properly close the cover before power-on. Otherwise, electric shock or explosion may occur.
When powering on a drive that has been stored for 2 years, use a voltage regulator to increase voltage
gradually. Otherwise, electric shock or explosion may occur.
To avoid electric shock, do not touch terminals when the drive is powered on.
To avoid electric shock, do not operate the drive with wet hands.
Before conducting maintenance, ensure that the power is cut off for 10 minutes, and check that the charging
indicator is completely off or the voltage of bus negative/positive is below 36 V. Failure to comply will result in
an electric shock.
Only professional personnel is qualified to replace the components. Do not leave any wire or metal parts inside
the drive. Failure to comply will result in a fire.
The bare parts of the terminal lugs in the main circuit must be wrapped with insulation tape. Otherwise,
electric shock may occur.
To Next Page
Loading...
Need help?
General
