Megmeet SPS-NE Series - Page 44

44
Function
code
Name
Value range
Default
value
Change
Thousands: Home correction mode
0: Single correction
1: Real-time correction
P31.02
Positioning mode
selection
Ones: Position mode of positioning
0: Relative position
1: Absolute position (relative zero)
Tens: Locking mode of positioning
0: Locked at the positioning point
1: Locked within the positioning range
Hundreds: Positioning sequence
0: No response to a newly received positioning
signal during positioning
1: Directly locating the new position when
receiving a new positioning signal during
positioning
Thousands: Action for positioning overlimit
0: Stop
1: Homing in reverse direction, and keep at
zero speed
2: Homing in reverse direction, and stop
0000H
×
P31.03
Berth position of home
searching
Ones: Berth position of home searching
0: Berth at the left of the home
1: Berth at the right of the home
Tens: Installation position of encoder
0: Installed at the motor shaft
1: Installed at the spindle
Hundreds: Reserved
Thousands: Reserved
0000H
×
P31.04
Start setting of internal
positioning
0: Manually set by the DI terminal
1: Auto start
0
×