116
Problem Cause Solution
The brewing unit
can no longer be
reinserted after
removal.
The brewing unit is not
properly locked.
Check whether the handle
for locking the brewing unit
is correctly engaged.
The actuator is not in
the proper position.
Switch the appliance o and
on again, and then press
simultaneously the buttons
for one- and two-cup dis-
pensing for longer
than 2 seconds. The actu-
ator moves into position.
Then reinsert the brewing
unit and make sure it is cor-
rectly locked into place.
Continuous as-
hing of all buttons
System error Switch o the appliance and
switch it on again via the
ON/OFF button ; if this
does not solve the problem,
send in the appliance to be
serviced.
Please contact the Melitta
®
hotline, if the above mentioned solutions do not
help to solve the problem: +49 571/ 86 1900.
Heft_Lattea_Fernost_2_3.indd 116 12.05.2014 15:15:44
To Previous Page