Melitta CaffeO Solo&milk

Questions and Answers

K
Keith PalmerSep 12, 2025
How to reinsert the brewing unit in my Melitta CaffeO Solo&milk?
- C
  Casey ThompsonSep 12, 2025
  If your Melitta Coffee Maker's brewing unit cannot be re-inserted after removal: 1. Check if the handle for the locking mechanism is correctly engaged. 2. If that's not the case, switch the appliance OFF and ON again, then simultaneously press the button for coffee dispensing and brewing strength for longer than 2 seconds. This will move the drive into the correct position. Then, re-insert the brewing unit and ensure it's correctly locked in place.
K
Kevin SmithSep 10, 2025
Why are the bean symbols flashing on my Melitta Coffee Maker when the container is full?
- D
  Deanna HansenSep 10, 2025
  If the bean symbols are flashing on your Melitta Coffee Maker even though the bean container is full, it means there is an insufficient quantity of ground beans in the brewing chamber. Press the button for coffee dispensing or brewing strength to resolve this.
V
Veronica PriceSep 9, 2025
What to do if all buttons are flashing on my Melitta Coffee Maker?
- R
  rollinschristopherSep 9, 2025
  If the Melitta Coffee Maker displays continuously flashing buttons, it indicates a system error. Try switching the appliance off and on again using the On/Off button. If the problem persists, the appliance should be sent to the service department.
P
paul27Sep 8, 2025
How to fix not enough milk froth being formed during frothing process in Melitta Coffee Maker?
- J
  James GarciaSep 8, 2025
  If not enough milk froth is formed during the frothing process, the nozzle of the steam pipe may be in the wrong position. Adjust the nozzle to the proper position. Alternatively, the steam pipe nozzle may be soiled, so clean the nozzle.
F
fcastilloAug 23, 2025
How to fix coffee only running drop-by-drop in my Melitta CaffeO Solo&milk?
- F
  fellisAug 23, 2025
  If coffee is only running drop-by-drop, the grind setting may be too fine. Set the grind to a coarser setting. Also, clean the brewing unit and descale if necessary. If needed, run a cleaning program.
B
barnesjonathanSep 6, 2025
What to do if the brewing unit cannot be re-inserted into my Melitta CaffeO Solo&milk?
- R
  Robert AverySep 6, 2025
  If the brewing unit cannot be re-inserted, first check whether the handle for the locking mechanism is correctly engaged. If that isn't the issue, the drive may not be in the right position. Switch the appliance OFF and ON again, then simultaneously press the button for coffee dispensing and brewing strength for longer than 2 seconds. The drive will move into position. Re-insert the brewing unit and ensure that it is correctly locked in place.
C
Christopher LeblancSep 5, 2025
Why is my Melitta CaffeO Solo&milk grinder making a loud noise?
- S
  Susan SmallSep 5, 2025
  If your grinder is making a loud noise, it could be due to foreign objects in the grinder. Contact the hotline for assistance.
D
David CareySep 3, 2025
What to do if the symbols for cleaning and stand-by flash alternately on my Melitta Coffee Maker?
- E
  Eric DouglasSep 3, 2025
  If the symbols for cleaning and stand-by are flashing alternately, ensure the brewing unit is properly inserted. If it is, the brewing chamber may be overfilled. Switch the appliance off and on again using the On/Off button. Repeat if necessary until standby mode is displayed.
S
Shane LewisSep 2, 2025
Why is my Melitta Coffee Maker symbol for the valve lighting up out of sequence?
- J
  Jesse HancockSep 2, 2025
  If the symbol for the valve lights up out of sequence, it means there is air in the lines inside the appliance. Open the valve until water runs out, then re-close the valve. Also, clean the brewing unit.
P
Pamela ClementsSep 1, 2025
What to do if my Melitta Coffee Maker does not brew coffee?
- E
  emitchellSep 1, 2025
  If your coffee maker isn't brewing coffee, it could be due to a couple of reasons. First, check if the water reservoir is filled and correctly inserted. If necessary, open the valve until water runs out, then re-close it. Another possibility is that the brewing unit is obstructed, so try cleaning it.

Melitta CaffeO Solo&milk Specifications

General

Type	Automatic Coffee Machine
Milk Frother	Yes
Pump Pressure	15 bar
Dimensions	20 x 32.5 x 45.5 cm
Brand	Melitta
Model	CaffeO Solo&milk
Color	Black/Silver
Voltage	220-240 volts
Programmability	Yes
Water Tank Capacity	1.2 liters
Bean Container Capacity	125 g
Power Consumption	1400 W
Material	Plastic
Included Components	Coffee machine, Milk container