ENGLISH
65
Integrated cleaning programme
The integrated cleaning programme removes residues including coffee oil residues
that cannot be eliminated by hand. It takes a total of approximately 15 minutes. The
cleaning symbol flashes during the entire process.
For optimal cleaning results we recommend that you clean the brewing unit before-
hand (see page 64).
Caution!
Run the integrated cleaning programme every 2 months or after appro-
ximately 200 brewed cups of coffee, at the latest however run the pro-
gramme when the symbol for cleaning is illuminated in the display.
Only use the cleaning tabs from Melitta
®
for automatic coffee makers.
These tabs are precisely matched to the Melitta
®
CAFFEO
®
. Use of
other cleaning agents can damage the appliance.
Please execute the integrated cleaning programme as follows:
Prerequisite: The appliance must be in stand-by mode.
1 Simultaneously press the button for single-cup dispensing and the
on/off button
for longer than 2 seconds.
The symbol for cleaning is flashing. The symbol for the drip tray is
illuminated.
2 Empty the drip tray and the coffee grounds container.
3 Re-insert the drip tray
without the coffee grounds container and place the
coffee grounds container under the outlet.
First, two rinsing processes will be executed.
The symbol for the ground coffee chute
is illuminated.
4 Open the lid of the ground coffee chute.
The symbol for the ground coffee chute is flashing.
5 Introduce a cleaning tab into the ground coffee chute (Fig. G).
6 Close the lid of the ground coffee chute.
–
–
→
→
→
→
To Next Page
Loading...
Need help?
General
