7 Foaming milk with milk2shower
Prerequisite: The appliance is ready for operation.
Place a bowl (e. g. a latte macchiato glass) under the milk canister.
Take off the milk canister and ll it with the milk2shower milk powder.
Place the milk canister on the magnetic holding point under the milk
shower (Fig. A, no. 13).
Turn the rotary switch for the milk shower clockwise to open the milk
shower.
The symbol for the milk shower is ashing. Approximately 90 ml of hot
water ows into the milk canister and generates the milk foam. The milk foam
runs out of the milk canister into the bowl below the canister. The water ow
will stop automatically after approximately 90 ml.
Turn the rotary switch for the milk shower anticlockwise to close the milk
shower (this can also be done prematurely if you desire less milk foam).
Now start the coffee dispensing process, e. g. to prepare a latte macchiato.
•
•
•
•
→
•
•
To Next Page
Loading...
