10 Function settings
Adjusting the water hardness
Use the included test strip to determine the water hardness in your area. Comply with
the instructions on the test strip package. The appliance is factory-adjusted to water
hardness 4. If you have inserted the Melitta Claris
®
water lter, water hardness 1 is set
automatically (see p. 53)
Prerequisite: The appliance is ready for operation, the standby symbol
is illuminated.
To maintain appliance quality adjust the water hardness as follows:
Simultaneously press the button for single-cup dispensing and the
button for two-cup dispensing for more than 2 seconds.
The standby symbol is ashing rapidly.
Press the button for single-cup dispensing to call the menu for adju-
sting the water hardness.
The symbol for the water lter is illuminated.
Press the button for brewing strength several times to select between
the four possible degrees of water hardness.
Your selection of water hardness in accordance with the table is indicated via
the bean symbols in the display.
Water hardness range Properties °dH °f
1:
soft 0 - 7.2 °dH 0 - 13 °f
2:
medium 7,2 - 14 °dH 13 - 25 °f
3:
hard 14 - 21.2 °dH 25 - 38 °f
4: ashing
very hard
(factory setting)
> 21.2 °dH > 38 °f
•
→
•
→
•
→
To Next Page
Loading...
