Press the On / Off button to conrm the selected degree of water
hardness.
All symbols in the display ash briey for conrmation. The appliance is
ready for operation, the standby symbol is illuminated.
Note
During the adjusting process, if you do not press a button within 60 se-
conds the appliance automatically reverts to standby mode.
Setting the timer for energy-saving standby mode
Additional information on energy-saving standby mode is provided on page 59. The
timer is factory-set to level 1 (15 minutes).
Prerequisite: The appliance is ready for operation, the standby symbol
is illuminated.
Adjust the timer as follows:
Simultaneously press the button for single-cup dispensing and the
button for two-cup dispensing for more than 2 seconds.
The standby symbol is ashing rapidly.
Press the button for single-cup dispensing twice to call the menu for
energy-saving standby mode.
The symbol for the water reservoir is illuminated.
Press the brewing strength button several times to select from four
possible times for the timer.
•
→
•
→
•
→
•
To Next Page
Loading...
