5 Inserting the Melitta Claris
®
water lter
A Melitta Claris
®
water lter for ltering out lime scale is included with the appliance.
After starting up the appliance for the rst time, please insert the water lter into
the appliance. If you use the lter, you will decalcify the appliance less frequently
and the water hardness will be set on hardness level 1 automatically (See page 60 in
this regard). The service life of your machine will be extended thanks to the reliable
protection against lime scale. The water lter should be changed regularly (every 2
months), at the latest however it must be changed when the symbol for the water lter
is shown in the display.
Prerequisite: The appliance is switched off.
Simultaneously press the button for brewing strength and the
On / Off button for more than 2 seconds.
The symbol for the water lter ashes during the entire change procedure.
The symbol for the drip tray is illuminated.
Empty the drip tray and then reinsert it.
The symbol for the water reservoir is illuminated.
Flip up the cover of the water reservoir and pull the water reservoir up
and out of the device.
Empty the water reservoir.
Screw the Melitta Claris
®
water lter into the thread on the oor of the
water reservoir.
Fill the water reservoir with fresh water to the Max. mark and reinsert it in
the appliance.
The symbol for the milk shower is illuminated.
Take off the milk canister and place a larger bowl under the milk shower.
Turn the rotary switch for the milk shower (Fig. A, no. 11) clockwise to
open the milk shower.
The symbol for the milk shower is ashing. Water runs into the bowl
under the milk shower.
•
→
•
→
•
•
•
•
→
•
•
→
To Next Page
Loading...
