17
WIKA operating instructions hydraulic high pressure controller model CPC8000-H
PN 0018708001B 11/2020 EN
EN
WARNING!
HIGH PRESSURE! High pressure liquids and gases are potentially hazardous. Energy stored in these gases and
liquids can be released suddenly and with extreme force. High pressure systems should be assembled and operated
only by personnel who have been trained in proper safety practices.
WARNING!
NOT EXPLOSION PROOF! Installation of this instrument in an area requiring devices rated as intrinsically safe is not
recommended.
WARNING!
POSSIBLE INJURY! The tubing, valves, and other apparatus attached to the controller must be adequate for the
maximum pressure which will be applied, otherwise physical injury to the operator or bystanders is possible.
CAUTION
USE THE PROPER PRESSURE MEDIUM! Use only clean, dry air or nitrogen for the CPC8000-HC and only
specified medium on the CPC8000-HM unless otherwise specified by Mensor.
CAUTION
As with most sensitive electronic equipment, switch the power switch off before connecting or disconnecting to a
power source to prevent data loss. Do not position the equipment so that it is difficult to disconnect the AC power
cord.
WARNING!
Detachable main power supply cord with inadequate ratings should not be used. See Section 10. Specifications for
power ratings.
Additional Warning and Caution notices are found throughout this manual.
3. Safety
To Next Page
Loading...
Need help?
General
