mensor WIKA CPC8000-H User Manual

30
WIKA operating instructions hydraulic high pressure controller, model CPC8000-H
PN 0018708001B 11/2020 EN
EN
6. Operation
Figure 6.4.1.2.4 Digit Step
6.4.1.4.3 Programs
The Programs entry method provides an automated way to interact with the CPC8000-H. Many settings or processes that can
be entered manually can be programmed into the unit and saved and used in the Program portion of the keypad entry screen.
Programs can be created, edited, deleted and saved in the Program application located under the Settings , then
Application tab. The example program (Figure 6.4.1.4.3) shows the selection of program named "Zero" and the sequence it will
start when the play button is pressed. The play button can be pressed again to pause the program at any step. The Up
and Down arrows can be pressed to skip or go back to a sequence step.
Figure 6.4.1.4.3 Programs

mensor WIKA CPC8000-H Specifications

General

Brand	mensor
Model	WIKA CPC8000-H
Category	Controller
Language	English