SETTINGS
eng 51
5. Press the "MODE" button to turn the "Depth/Seatemp"
option on ("Yes") or off ("No").
MODE
33078
Tabs
Steering
Speed/GPS
[DOWN]
[EDIT]
Depth/Seatemp
Ext. Sensors
Yes
Trim
No
No
No
No
6. Use the "+" or "–" button to highlight the options and use the
"MODE" button to turn the option on ("Yes") or off ("No").
NOTE: The "Tabs" option must be on ("Yes") for the "Tabs
Source" to be activated. The "Tabs Source" will default to the
engine location the gauge is set up to monitor. The engine
location can be changed to starboard ("STBD"), port ("PORT"),
starboard 2 ("STB2"), port 2 ("PRT2").
7. Press the "–" button to highlight the "Exit" option. Press the
"MODE" button to exit the "Ext Sensors" menu.
Setting the Offsets
The "Offsets" menu allows for compensation for inaccurate
sensors, sets a transition speed from one speed sensor to
another, inverts a steering sensor, and corrects the amount of
fuel used. Sensors that can be modified are; sea temperature,
depth, paddle wheel hertz, pitot pressure, and steering position.
1. While in the "Main Menu," press the "–" or "+" button to
highlight the "Settings" menu.
To Next Page
Loading...
Need help?
General
